求職服務專線
台北 02-2912-6104 轉 2
   02-7703-3104 轉 2
意見回饋
廠商求才專線
台北 02-2912-6104
   02-7703-3104
台中 04-3700-6104
上海 86-21-50277104 轉 1
意見回饋

[派遣至外商軟體龍頭] Failure Analysis Lab Engineer 失效性分析 - 105SL

  • 全職

Responsibilities:
• Implementation of electrical and/or physical testing techniques and standard operating procedures
• Responsible for new instrument installation, new method development and validation of methods
• Plans testing capacities according to internal and external requirements.
• Conduct investigation and report any deviations of Laboratories measurement,
• Draws up quarterly, monthly, and specialized reports according to working documents for the analysis and/or measuring methods.
• Supports problem solving in production lines by recommending appropriate internal & external laboratory techniques.
Perform routine testing using specific methods:
• Support researchers and scientists in exploratory and validation studies
• Ensure reliable and accurate data collection based on available best practices.
• Complete documentation through accurate data recording and/or electronic notebook to ensure timely submission of test results.
Perform routine housekeeping which include the following:
• Daily checks
• Inventory management (products and consumables) including but not limited to providing timely communication of purchase cycle, obtain quotes for review, following-up on deliveries and timely submission of delivery documents.
• Administrative duties including but not limited to updating inventory & equipment database and order tracking sheets.
Perform basic equipment maintenance which may include but not limited to the following:
• Equipment checks especially if using calibrated equipment.
• Maintain equipment records/ logbooks to ensure required safety and quality standard is maintained.

Requirement:
• Fluent and confidence in English communication
• Bachelor’s degree in engineering or Applied Science (Chemistry, Physics)
• At least 2 years laboratory experience in semiconductor or other manufacturing industries
• Familiar to use the multimeter for basic PCBA board level measurement.
• Familiar to operate the Oscilloscope for High Speed and Low Speed signal measure based on datasheet definition.
• Capable to check Schematic and layout thru Cadence Concept-HDL and Allegro tool.
• Capable for PCBA rework, Soldering
• Capable for system test setup for issue reproduce including remote debug system, SW installation.
• Knowledge in good laboratory practices, ISO/ IEC17025 and MSA will be added advantage.

工作條件

  • 接受身份: 上班族
  • 工作經歷: 三年以上
  • 學歷要求: 大學以上
  • 語文條件: 英文 -- 聽 /中等、說 /中等、讀 /中等、寫 /中等
  • 其它條件: 未填寫

福利制度

獎金、福利,依照各公司及各職務而有所不同。

更新日期:2021-06-09

應徵方式

  • 職務聯絡人: SylviaLiu
  • 聯絡E-Mail: 我要應徵
  • 洽: 不接受電洽
  • 洽: 不接受親洽

應徵分析

兩週內0-5人應徵
經歷分佈
目前無資料
學歷分佈
目前無資料
一零四資訊科技享有網站內容著作權 © 2001- 2021 104 Corporation All Rights Reserved